How to prevent the rosin press filter bag from blowing out

How to prevent the rosin press filter bag from blowing out?

Making solvent-free rosin can be a relatively simple process, but there is still a lot that can go wrong. 

One of the most common problems encountered by rosin producers is "blowout". 

Burst occurs when your rosin press filter bags burst during the pressing process, allowing unwanted plant material to mix with the rosin, which can ultimately ruin your end result.

There are many factors that can cause a blowout to occur, most of which are due to poor technique. 

So, if you suffer from blowouts on a regular basis, here’s everything you need to know in order to fix the problem once and for all.

Use high quality rosin press filter bags.

Some rosin press filter bags are not as durable as others.

Normally double stitched is strong enough.

Doule stitched rosin bags

Another easy way to avoid blowouts is to use doulbe stitched rosin filter bags at the same time, or "dual bags." 

Extra bags give you extra security without worrying about bursting, because if one bag does fail, the other will save the world.

Many commercial presses use double bagging as a precaution because even with perfect technology and top-of-the-line equipment, the chances of a blowout are slim. 

Also, if you do try double Rosin bagging, make sure the seams of each bag are on opposite sides of each other, this should guarantee maximum structural integrity.

Do not overfill the rosin press filter bag.

Bags that are overfilled can easily burst or slip.

Leave 1/2 inch space at the top to fold and close the rosin press bag.

Fill the rosin bag evenly.

A uniformly filled rosin press bag will apply consistent pressure to the entire surface area of the bag.

An uneven bag may experience more pressure in one area than another, causing it to burst.

Rosin bags replacement.

Fold a piece of parchment in half and secure it to the top and bottom panels with magnets.

Place the rosin filter bag in the center.

Remove the top magnet so the top of the dryer sheet folds down onto the ba